Operating Your Dryer - Fisher & Paykel DE09 Use And Installation Manual

WARNING – To reduce the risk of fire, electric shock, or injury to persons
when using your appliance read the IMPORTANT SAFETY INSTRUCTIONS
Features and appearances may vary
Drying Selections. Select the proper heat on the Fabric
1
Care selector for your load.
NOTE: Drying times will vary according to the type of
heat used (Electric, Natural gas or LP gas), size of load,
types of fabrics, wetness of clothes, and condition of
exhaust ducts.
Should be used with cycles indicated
Drying Automatic
Selections Cottons
Cottons
High Heat
Perm. Press
Medium Heat
Knits/Delicates
Low Heat
Fluff
No Heat*
*Fluff-No Heat option can be used with an automatic cycle, but for best
performance it is recommended to be used with a timed cycle.
Cycle Selector. Turn the Cycle Selector to the desired
2
cycle setting. The selector may be turned in either
direction.
Press Guard Cycle. (Available on some models.)
3
The Press Guard cycle operates only with the
Automatic Permanent Press and Automatic Cottons
cycles. Turn the Press Guard knob to SET or press the
pad to select, and turn the Cycle Selector Dial to the
desired amount of heated drying time.
10

OPERATING YOUR DRYER

before operating this appliance.
1
Automatic
Perm. Press Timed
3 4 5
To minimize the wrinkle setting in clothes, the Press
Guard cycle provides from15 to 20 minutes of no-heat
tumbling after the clothes are dry.
Used the End Cycle Signal to remind you to remove
the dried laundry.
End Cycle Signal. (Available on some models.)
4
Set End Cycle Signal, if desired. This signal operates
with any cycle on some models. The control can be set
anywhere between OFF and LOUD, depending on the
desired sound level. The signal will start to sound just
before the end of the cycle to remind you to remove the
clothes. To stop the signal while sounding, turn the
signal control to OFF or advance the Cycle Selector to
OFF.
This signal should always be used when drying
polyester knits or permanent press items which should
be removed as soon as the dryer stops to help prevent
setting of wrinkles.
If the signal is on and you choose the Press Guard
cycle, you will hear the signal sound on and off
throughout the cycle. This reminds you that the clothes
are dry.
5
Start. Turn the Start knob or press the Push to Start
button to start the dryer. (Opening the door during
operation stops the dryer. To restart, close the door and
follow above directions.)
2