Power Connector Cable; Keyboard/Top Cover - HP ProBook 11 G2 Education Edition Maintenance And Service Manual

Power connector cable

NOTE: The power connector cable is included in the Cable Kit, spare part number 809856-001.
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the bottom cover (see
Remove the power connector cable:
1. Disconnect the power connector cable (1) from the system board.
2. Release the power connector cable from the retention clips (2) built into the base enclosure.
3. Remove the Phillips PM2.5×8.6 screw (3) and the two Phillips PM2.5×5.8 screws (4) that secure the
display left hinge to the base enclosure.
4. Swing the left display hinge (5) to the open position.
5. Remove the power connector cable (6).
Reverse this procedure to install the power connector cable.

Keyboard/top cover

NOTE: The keyboard/top cover spare part kit does not include the TouchPad cable or the TouchPad button
board cable. The TouchPad cable and the TouchPad button board cable are included in the Cable Kit, spare
part number 846982-001.
Battery on page 24).
Bottom cover on page 26).
Component replacement procedures 47