Milnor 30015V7J Service Manual page 13

Tag Guidelines for the Models Listed Below
The following entries explain the installation tags. Each entry includes: 1) the tag illustration, 2)
the tag part number displayed st the bottom of the tag, and 3) the meaning of the tag.
Display or Action
PELLERIN MILNOR CORPORATION
Explanation
Read the manuals before proceeding. This symbol appears on
most tags. The machine ships with safety, operator, and routine
maintenance guides for customer use. Milnor dealer manuals for
installing, servicing, and commissioning this machine are also
available from the Milnor Parts department.
B2TAG88005: This carefully built product was tested and
®
inspected to meet Milnor
(identification mark of tester).
B2TAG93013: This bearing housing was lubricated at the
Milnor factory before shipment.
B2TAG94081: Motor must rotate in this direction. On single
motor washer-extractors and centrifugal extractors, the drive
motor must turn in this direction during draining and extraction.
This tag is usually wrapped around a motor housing. If the motor
turns in the opposite direction when the machine is first tested,
the electrical hookup is incorrect and must be reversed as
explained in the schematic manual.
B2TAG94097: The cylinder must rotate counterclockwise
during draining and extraction (spin) when viewed from here
(rear of machine). Otherwise, reverse the electric power
connections, as explained in the schematic manual.
B2TAG94118: Do not strike shipping container during fork-
lifting. Fragile components inside.
B2T2001013: Hot water connection.
9
performance and quality standards by