Vivotek VC8101 User Manual page 15

Hardware Reset
The reset button is used to reset the system or restore the factory default settings. Sometimes
resetting the system can return the camera to normal operation. If the system problems remain
after reset, press the reset button longer to restore the factory settings and install again.
Reset: Press and release the recessed reset button with a straightened paper clip. Wait for the
Network Camera to reboot.
Restore: Press and hold the recessed reset button for at least several seconds to restore. Note
that all settings will be restored to factory defaults.
SD/SDHC/SDXC Card Capacity
This network camera is compliant with SD/SDHC/SDXC 32GB, 64GB, and other preceding
standard SD cards.
LED Definition
Item LED Status
1 Steady Red
Red LED off
2 Steady Red + blinking
LED on for 1 sec and off for another)
Steady Red +
3 Blinking Red
every 1 sec. (Red
LED on for 1 sec. and off for another)
4 Blinking Red
every 0.15 sec
Green every 1 sec.
Green LED off
every 0.15 sec. + Blinking
LED on for 0.15 sec. and
every 0.15 sec. + blinking
Description
Power on and system booting
Powered off
(Green Network heartbeat
Network disconnected
Green Upgrading firmware
Green
Green Restoring defaults
VIVOTEK
User's Manual - 15