Operation - VuQube V10 Owner's Manual

IMPORTANT! For satellite acquisition, there must be a clear "line of sight" to the southern sky. Mountains,
buildings, trees, telephone poles, etc. can all block the satellite signal from reaching the
antenna (inside the VuQube).
NOTE: Pressing and releasing buttons on the remote control will produce an electronic click.
1. Determine the look angle for your desired satellite at your present location from the appropriate
map in Section 5 ELEVATION MAPS, or by entering the local zip code into your receiver's
setup menu (see your receiver's owner's manual).
2. Follow the instructions in your receiver's owner's manual and navigate to the signal meter
screen. Select the appropriate transponder:
DIRECTV ®
®
DISH
Bell TV
3. Press and hold POWER on VuQube remote until it turns ON.
The remote will display the current antenna elevation angle.
4. Use the UP and DOWN arrows to change the
antenna elevation angle as shown on the
remote control to the proper elevation
determined in step 1.
IMPORTANT! STEP 5. You must watch your TV for signal strength while rotating the antenna in step 5. See
your receiver's owner's manual to determine how to display the signal meter screen on your TV.
When pressing the left and right arrows, the remote will continuously beep with a short pause in
between: (beep - beep - beep...).
If the unit reaches its rotational limit in either direction, the remote will display REVERSE
DIRECTION and beep rapidly: (beep beep beep...) Press other rotational arrow to reverse
direction.
5. With the satellite signal meter screen displayed on your TV, use the
LEFT and RIGHT arrows to rotate the antenna and watch for signal
to appear on the meter.
Page 8
Section 3
SATELLITE ACQUISITION
101 = 19 119 = 22
61.5 = 14 110 & 119 = 11
82 & 91 = 11

OPERATION

129 = 21