Automatic Satellite Switching For Dish And Bell Tv - VuQube V10 Owner's Manual

Section 4
The satellite TV channels you watch may be broadcast from more than one satellite. When selecting
a channel that is broadcast from a different satellite, the VuQube antenna must switch to the new
satellite in order for you to view that channel.
The VuQube can be configured to automatically switch between satellites. To do this you must store
all applicable satellites into memory in the correct order and then activate the automatic satellite
switching feature. Doing this allows the VuQube to automatically change satellites as necessary
when you simply select a new channel with your receiver's remote control.
To enable the automatic satellite switching feature you must follow this 3 step configuration process:
Step A: CHECK SWITCH TEST. Run a check switch test (before satellite acquisition) to clear
the memory of the receiver (page 11). This is a one time procedure.
Step B: SATELLITE ACQUISITION. Lock on and store each satellite's location in the VuQube's
memory (page 12).
Step C: SWITCHING MODE AND FINAL CHECK SWITCH TEST. Put the VuQube in the
proper switching mode and run a check switch test to configure the receiver for
automatic switching (pages 13-15).
NOTE: After running the check switch test in step C you will not have to run it again (see page 13 for exceptions).
GO TO PAGE 11 AND BEGIN WITH STEP A.
Page 10
AUTOMATIC SATELLITE SWITCHING FOR
DISH AND BELL TV