Fcc User Information - VuQube V10 Owner's Manual

Mobile satellite tv antenna
Table of Contents

Advertisement

Main Components
VuQube Antenna
Model #: VQ1
FCC ID: UUM433A
IC: 6873A-443A
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1) This device must not cause harmful
interference, and
2) This device must accept interference received
including interference that may cause
undesired operation.
IMPORTANT! This device must not be co-located with other transmitters to ensure compliance with FCC RF
exposure requirements.
Please note that changes or modifications to the VuQube or VuQube Remote not expressly
approved by King Controls could void the purchaser's or user's authority to operate this
equipment.
The VuQube and VuQube Remote have been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that the interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC USER INFORMATION

Section 9
VuQube Remote
Model #: VQ1R
FCC ID: UUM433RA
IC: 6873A-443RA
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1) This device must not cause harmful
interference, and
2) This device must accept interference received
including interference that may cause
undesired operation.
Page 23

Advertisement

Table of Contents
loading

Table of Contents