Hoshizaki FM-170EE-HC Service Manual page 30

26) Immerse these parts in the sanitizing solution for about 15 minutes.
27) Rinse these parts thoroughtly with clean water.
28) Refit the removed parts in reverse order.
29) Close the water supply tap.
30) Remove the Control Water Valve by
releasing the Fitting Nut. Do not lose the
Packing (See Fig. 12).
31) Remove the Mesh Filter from the inlet
side of the Valve (See Fig. 12).
32) Clean the Mesh using a brush. Rinse
with fresh water.
33) Refit the Mesh into the Valve and the Valve into its correct position.
34) Open the water supply tap and check for leaks.
35) Refit the Top and Front Panels securely with the screws.
36) Plug in the icemaker and make ice for 30 minutes.
37) Unplug the icemaker and pour warm water into the Storage Bin to melt the ice.
38) Plug in the icemaker and start the automatic icemaking process.
1. After cleaning, do not use ice made from the sanitizing solution. Be
careful not to leave any solution in the Storage Bin.
2. Follow carefully any instructions provided with the bottles of cleaning or
sanitizing solution.
3. Never run the icemaker when the Reservoir is empty.
If the solution is left on these parts, they will corrode.
IMPORTANT
IMPORTANT
27
Coil
Do not remove
Filter
Fig. 12
Packing