Check Safety Interlock System; Clean Debris Off Mower - Snapper NXT 7800752 Operator's Manual

Table of Contents

Advertisement

Available languages

Available languages

Check Safety Interlock System

1. Start the mower.
2. Release the blade control. The engine must stop within
3 seconds.
If the engine does not stop, do not use the mower. Bring the
mower to an authorized dealer for service.

Clean Debris Off Mower

!
WARNING
DO NOT attempt any maintenance, adjustments or service
with engine and blade running. STOP engine and blade.
Remove starter insert. Disconnect spark plug wire and
secure away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for all com-
ponents to cool. Wear heavy leather gloves when handling
or working around cutting blades. Blades are extremely
sharp and can cause severe injury.
1. Clean dirt and debris from the top of the mower deck.
2. Clean any debris buildup on or around the engine, etc.
While cleaning, check components for wear or damage.
Replace worn or damaged components immediately.
Washout Port
!
WARNING
• Use appropriate eye protection.
• Keep people and pets out of the area.
• Stay behind the handle while the engine is running.
• Do not attempt mowing operations while using the
washout port.
• Do not attempt to look under or reach under the mower
deck for any reason while using the washout port.
Serious injury can result.
The washout port allows hands-free cleaning of the
underside of the mower deck. To use the washout port:
1. Be sure the grass bag and side discharge deflector are
removed.
2. Set the height of cut to the lowest position.
3. Move the mower to a level, paved surface.
4. Stop the engine.
5. Connect the male end of a standard garden hose to the
washout port connector (A, Figure 15).
6. Turn on the water supply to the garden hose.
7. Start the engine and run until no more debris emerges
from under the mower deck.
8. Stop the engine.
9. Turn off the water supply to the garden hose.
10. Disconnect the garden hose from the washout port
connector.
en
11. Start the engine and run for 2-3 minutes, to allow the
underside of the mower deck to dry.
!
Figure 15: Washout port
!
Maintenance
A
17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nxt 7800782

Table of Contents