Cutting Height Adjustment; Mulching Operation; Installing The Discharge Deflector - Snapper NXT 7800752 Operator's Manual

Cutting Height Adjustment

Turn the cutting height adjust switch (A, Figure 6) in the
direction indicated to raise or lower the cutting height. The
cutting height indicator (A, Figure 7) indicates the current
cutting height. The movable cutting height marker tabs
(B) can be set to easily reference the three most preferred
cutting heights.
NOTE: Cutting height can be adjusted without mower
running.
Figure 6: Adjusting cutting height

Mulching Operation

For best mulching results, cut up to a maximum of 1/3 of
grass length and mulch ONLY when grass is dry.
1. Make sure the discharge deflector and grass bag are
removed, and the mulching plug is installed.
2. Set the cutting height adjust to the highest cutting
position.
3. Proceed mowing slowly. Gradually lower the cutting
height to obtain the best combination of cutting and
mulching performance. Cutting too much grass in one
pass, or cutting wet heavy grass may cause clumping or
plugging of the mower deck.
en
1.25 in
A
Figure 7: Cutting height indicator

Installing the Discharge Deflector

!
DO NOT attempt any maintenance, adjustments or service
with engine and blade running. STOP engine and blade.
Remove starter insert. Disconnect spark plug wire and
secure away from spark plug. Engine and components
are HOT. Avoid serious burns, allow sufficient time for all
components to cool.
1. Raise the mulching cover (A, Figure 8).
2. Install the deflector (B) to the deck under the mulching
cover, making sure that the locking tabs on the deck (C)
go through the slots in the deflector (B).
3. Lower the mulching cover against the deflector.
B
Figure 8: Installing the discharge deflector
B
A
WARNING
C
Operation
4.00 in
!
A
11