Cutting Height Adjustment - Snapper YARD CRUISER HYDRO DRIVE 2 Series Safety Instructions & Operator's Manual

Section 2 - OPERATING INSTRUCTIONS

2.3.5. CUTTING HEIGHT ADJUSTMENT

This machine has seven different cutting height
positions. IMPORTANT: When positioning the cutting
deck into a higher cutting position, pull up on the deck
lift handle only, it is not necessary to pull up on the
release lever at the same time. Use the release lever
when moving deck cutting height to a lower cutting
position.
1. Grasp both handles together to disengage
latch.
2. Raise or lower handles to desired height.
3. Release lower handle to engage latch. See
Figure 2.9.
DECK LIFT
HANDLE
RELEASE
LEVER
CONNECTING BAR OMITTED IN THIS
VIEW FOR CLARITY
FIGURE 2.9
DECK LIFT HANDLE SHOWN
IN HIGHEST NOTCH.
DETENT
PLATE
10