Table of Contents
Advertisement
AXIS Q6042-S PTZ Dome Network Camera
Hardware Overview
4. When the pressure inside the camera housing reaches 0.5 bar (7 psi) the pressure relief valve will open. Place your hand
over the pressure relief valve to verify that the gas is flowing out.
5. Keep the gas flowing through the camera housing for one minute before removing the chuck from the inlet valve.
6. Lift the pressure relief valve to let the overpressure out of the camera unit.
7. Repeat the filling process a total of 3 times, leaving the the camera pressurized the last time.
8. Put the caps back on the inlet valve and the pressure relief valve.
Connectors and Buttons
For technical specifications, see page 65.
Multi-connector
Terminal connector for connecting the supplied media converter switch, which provides the following signals:
•
DC Power
•
Network (Ethernet 10/100Base-T)
•
Input/Output (I/O)
The supplied multi-connector cable is required in order to maintain the product's NEMA/IP rating. For more information, see
Multi-Connector Cable on page 59.
SD Card Slot
NOTICE
TICE
NO
NO
TICE
• Risk of damage to SD card. Do not use sharp tools or excessive force when inserting or removing the SD card.
• Risk of data loss. To prevent data corruption, the SD card should be unmounted before removal. To unmount, go to Setup >
System Options > Storage > SD Card and click Unmount.
This product supports SD/SDHC/SDXC cards (not included).
For SD card recommendations
Control Button
For location of the control button, see Hardware Overview on page 7 .
The control button is used for:
•
Resetting the product to factory default settings. See page 58.
•
Connecting to an AXIS Video Hosting System service. See page 50. To connect, press and hold the button for about 3
seconds until the Status LED flashes green.
•
Connecting to AXIS Internet Dynamic DNS Service. See page 50. To connect, press and hold the button for about 3 seconds.
LED Indicators
Status LED
Unlit
Green
Indication
Connection and normal operation.
Shows steady green for 10 seconds for normal operation after startup completed.
Advertisement
Table of Contents
