Special - EverFocus HDCCTV EZH5242 User Manual

5.6 SPECIAL

In this section, the user can configure a variety of special
settings.
CAM TITLE submenu
On the SPECIAL page, scroll to CAM TITLE and scroll sideways
to switch it ON, then press ENTER to access this function's
edit page where you can write or edit the camera's name,
which will be displayed in the position you select on this
page.
Use your Direction and Enter buttons to select and confirm
letters, numbers, etc. After entering a name, highlight the
POS option and press ENTER to see where the name will be
placed, then use your direction buttons to drag it to the
position you want it to be. Press CLR to clear one letter of
the input.
D-EFFECT submenu
FREEZE – Turn this ON to freeze the image. This will
undo the MIRROR option below.
MIRROR – Scroll between Rotate, V-Flip, Mirror, and Off.
D-ZOOM – Switch this setting ON and press ENTER to
access its submenu, where you can set the PIP, the zoom
level, the Pan and Tilt direction. Press ENTER on the
DEFAULT line to return to default settings.
NEG. IMAGE – Switch this ON to see a negative-exposure image of the video feed.
Note: The D-Zoom setting is not functional on the SD test-out mode. If you connect an SD
monitor to the test-out port on the rear panel of the camera and then turn on the D-Zoom
setting in the OSD menu, the OSD menu will be turned off on the SD monitor. To turn on the
OSD menu on the SD monitor, click the Reset button on the rear panel of the camera.
MOTION submenu
Switch this function on and press ENTER to configure
motion detection zones.
SELECT – Select one of the possible three motion detection
zones that you can set up.
DISPLAY – Select ON to activate the zone you selected above.
Press ENTER to open the POSITION screen where you can
position the detection zone's indicator block. Press ENTER
again to save the block's top and left border positions and
move on to the SIZE screen, where you can set the block's bottom and right borders.
17