Schwinn 130 Assembly Manual / Owner's Manual page 34

Condition/Problem
Console shuts off (enters
sleep mode) while in use
Unit rocks/does not sit
level
Pedals loose/unit difficult
to pedal
Clicking sound when
pedaling
Seat post movement
34
Things to Check
Check data cable
connections/orientation
Check Servo Motor
(requires shroud removal)
Check electrical (wall)
outlet
Check connection on
console
Check data cable integrity
Check data cable
connections/orientation
Reset Machine
Check magnet position
(requires shroud removal)
Check Speed Sensor
(requires shroud removal)
Check leveler adjustment
Check surface under unit
Check pedal to crank arm
connection
Check pedal to crank arm
connection
Check locking pin
Check adjustment knob
Be sure cable is connected securely and oriented properly. Re-
seat all connections. Small latch on connector should line up and
snap into place.
If magnets move, adjust until they are within the proper range.
Replace Servo Motor if not functioning properly.
If the above steps do not resolve the problem, contact Customer
Care for further assistance.
Make sure unit is plugged into a functioning wall outlet.
Connection should be secure and undamaged. Replace adapter
or connection at unit if either are damaged.
All wires in the cable should be intact. If any are cut or crimped,
replace cable.
Be sure cable is connected securely and oriented properly. Small
latch on connector should line up and snap into place.
Unplug unit from electrical outlet for 3 minutes. Reconnect to
outlet.
Magnet should be in place on pulley.
Speed sensor should be aligned with magnet and connected to
data cable. Realign sensor if necessary. Replace if there is any
damage to the sensor or the connecting wire.
Adjust levelers until bike is level.
Adjustment may not be able to compensate for extremely uneven
surfaces. Move bike to level area.
Pedal should be tightened securely to crank. Insure connection is
not cross-threaded.
Remove pedals and reattach.
Be sure adjustment pin is locked into one of the seat post adjust-
ment holes.
Be sure knob is securely tightened.
Solution