Threading The Machine - Janome Memory Craft 8200QC Instruction Book

Janome 8200 Sewing Machine Instruction Manual
v
x
b
n
m
w
x
e
e
c
t
r
b n m
u
www.janomeflyer.com
z
c
z
q
v
y
i

Threading the Machine

Raise the presser foot lifter to raise the presser foot.
Turn the power switch on.
Press the needle up/down button to raise the take-up lever
to the highest position.
Press the lockout key or turn the power switch off.
Pass the thread in the order from z to m.
CAUTION:
Always make sure to press the lockout key to lockout
the machine or turn the power switch off before
threading the machine.
z Hold the thread with both hands and pass the thread
into the guide slot.
q Guide slot
x Hold the thread with both hands and draw the thread
around the corner of the guide.
Firmly pull the thread toward you along the right
channel until the thread snaps.
w Corner of the guide
e Right channel
c Draw the thread down along the right channel and
around the bottom of the thread guide plate. Pull the
thread up along the left channel.
e Right channel
r Thread guide plate
t Left channel
v While holding the thread at the spool, firmly draw the
thread up and to the back of the take-up lever. Draw
the thread forward to slip it into the eye of the take-up
lever.
y Eye of the take-up lever
b Then pull the thread down along the left channel and
through the lower thread guide.
u Lower thread guide
n Slide the thread behind the needle bar thread guide
on the left.
i Needle bar thread guide
m Thread the needle with the needle threader (refer to
the next page).
MC8200 Owners Manual/ User Guide
21