Chlorine Clear Water Plan; Ozonator Clear Water Plan - Cal Spas F 1239 Owner's Manual

Chlorine Clear Water Plan

Day One (Monday)
1. Test spa water using "Chlorine Test Strips".
2. Based on the Test Strip readings:
• First adjust total alkalinity (acceptable range
of 80-120 ppm)
• Then adjust the pH if needed (range is
between 7.2 to 7.8).
• Add 2 tablespoons of Chlorine Granules.
• The recommended level of Chlorine is 3-5
ppm.
3. Add 2 oz of "Stain and Scale Defense".
4. Remove dirty filter from the spa and rinse off.
5. Place your extra clean filter cartridge back into
the spa.

Ozonator Clear Water Plan

This plan and its chemical dosages are intended for
spas equipped with the optional ozonator.
Start Up
1. Follow the Spa Start Up procedures for Chlorine
"Clear Water Plan".
Note: Filtration time may need to be increased with
heavy bather load.
Day One (Monday)
1. Test spa water using chlorine "Test Strips". (You
will need to use a small amount of chlorine as a
supplemental sanitizer.)
2. Based on the Test Strip readings:
• First adjust total alkalinity (acceptable range
of 80-120 ppm),
• Then adjust the pH if needed. (Range is
between 7.2 to 7.8.)
• Add 1 tablespoon of Chlorine Granules.
2012 Portable Spa
LTR20121001, Rev. A
6. Vacuum debris from the bottom of your spa with
the "Spa Vacuum".
Day Two (Wednesday)
1. Test spa water using Chlorine Test Strips.
2. Based on the Test Strip reading: Adjust total
alkalinity, then the pH if needed.
Day Three (Friday)
1. Test spa water using Chlorine Test Strips.
2. Based on the Test Strip reading:
• Adjust total alkalinity, then the pH if needed.
• Add 2 tablespoons of Chlorine Granules (if
needed).
3. Add 2 oz of Oxidizer Shock to spa. Run Spa for 15
minutes with cover off.
4. Replace cover.
• The recommended level of Chlorine is 1-3
ppm.
3. Add 2 oz of "Stain and Scale Defense".
4. Remove dirty filter from the spa and rinse off.
5. Place your extra clean filter cartridge back into
the spa.
6. Vacuum debris from the bottom of your spa with
the "Spa Vacuum".
Day Two (Friday)
1. Test spa water using Chlorine Test Strips.
2. Based on the Test Strip reading:
• Adjust total alkalinity, then the pH if needed.
• Add 1 tablespoon of Chlorine Granules (if
needed).
3. Add 2 oz of Oxidizer Shock to spa. Run Spa for 15
minutes with cover off.
4. Replace cover.
27
www.calspas.com