Table of Contents
Advertisement
Installation
Install the telephone base as shown below. If you subscribe to high-speed Internet
service (DSL - digital subscriber line) through your telephone line, you must install a DSL
filter on the DSL line. If you want to mount your telephone on a wall, use the included
wall mount bracket and refer to Wall mount installation in the online user's manual for
details.
Electrical outlet not
controlled by a
wall switch
Plug the large end
of the base power
adapter into an
electrical outlet not
controlled by a wall
switch.
Plug the small end
of the base power
adapter into the
power jack on
the bottom of the
telephone base.
IMPORTANT INFORMATION:
Use only the power adapter provided with this product. To obtain a replacement, visit our website
www.telephones.att.com
at
1 (866) 288-4268
or call
.
A DSL filter (not
included) is required if
you have DSL high-speed
Internet service.
Telephone line cord
1 (800) 222-3111
3
Telephone wall jack
Plug the other end
of the telephone line
cord into a telephone
wall jack.
Route the cords
through the slots.
Plug one end of the
telephone line cord
into the TEL. LINE
jack on the bottom of
the telephone base.
. In Canada, dial
Advertisement
Table of Contents
