Installing A Dvd Drive - IBM 4348 Installation Manual

System x3100

Hide thumbs Also See for 4348:

Table of Contents

v SATA 0 and SATA 1 connectors are hard disk drives connectors and SATA 2 and

v The electromagnetic interference (EMI) integrity and cooling of the server are

v For a complete list of supported optional devices for the server, see

Installing a DVD drive

To install a DVD drive in bay 1 or 2, complete the following steps:

System x3100 Type 4348: Installation Guide

SATA 3 connectors are optical drive connectors.

protected by having all bays and PCI or PCI Express slots covered or occupied.

When you install a drive or PCI or PCI Express adapter, save the EMC shield

and filler panel from the bay, or the PCI or PCI Express adapter slot cover in the

event you later remove the drive or adapter.

http://www.ibm/com/servers/eserver/serverproven/compat/us/.

1. Read the safety information that begins on page v and "Installation guidelines"

on page 7.

2. Turn off the server and peripheral devices, and disconnect the power cords

and all external cables.

3. Remove the side cover (see "Removing the side cover" on page 10).

4. Remove the bezel (see "Removing the bezel" on page 11).

5. Use your fingers to press in on the drive-bay filler panel release tab on the

inside of the bezel and remove it from the bezel; then, pry the EMC shield

away from the server. Store the filler panel and EMC shield in a safe place.

Release tab

Table of Contents