Sharp mxb381 Operation Manual page 426

Specifying the original scan size (by paper size)
If the size of the placed original is different from the displayed original size or you wish to change the original size, you
must touch the [Original] key and directly specify the original size. Place the original in the document feeder tray or on
the document glass and follow the steps below.
Select the mode and display the image settings screen.
(1) Touch the tab of the mode that you wish to use.
1
(2) Touch the [Original] key.
The original size set in the system settings appears to the right of the [Original] key.
☞
IMAGE SETTINGS
Scan/Original
Scan Size
A4
2
2-Sided 2-Sided
Booklet Tablet
Scan/Original
A5 216x330
B5 216x340
3
A4
216x343
Size Input
• If you are sending a long original, touch the [Long Size] key. Use the automatic document feeder to scan a long
original. The maximum width that can be scanned is 500 mm (19-5/8") (the maximum height is 216 mm (8-1/2")).
• To specify an Inch size for the scan size, touch the [AB
scan size.
Scan/Original
Scan Size
B5
4
2-Sided 2-Sided
Booklet Tablet
When [Long Size] is selected, the 2-sided scanning setting and send size cannot be changed. In addition, when only scan
destinations are selected for scan transmission or metadata transmission, scanning will take place in Mono2.
(page 5-49)
OK
100% Send Size
Auto
Image Orientation
(1) (2)
OK
16K
AB
Inch
Long Size
OK
100% Send Size
Auto
Image Orientation
Touch the [Scan Size] key.
Specify the scan size.
(1) Touch the appropriate original size key.
(2) Touch the [OK] key.
Inch] key to highlight the [Inch] side and then specify the
Touch the [OK] key.
5-52
SCANNER/INTERNET FAX
Contents