Operating Instructions - Cambridge Audio Azur 640C User Manual

OPERATING INSTRUCTIONS

Loading a a nd u u nloading d d iscs
1. Press the Standby/On switch.
2. Press the Open/Close button.
3. When the disc tray has opened fully, place a disc carefully in the tray
with the label side facing up.
4. To close the disc tray, press the Open/Close button again. When the
tray with a correctly loaded disc is fully closed, the disc will start
turning automatically. After the CD player has read the disc it will be
ready to play. Pressing Play will also close the tray and start playing
the disc
5. The disc tray can be opened at any time by pressing the Open/Close
button. Only remove the disc after the tray has fully opened.
Note
Do not put anything except a Compact Disc into the tray, foreign objects
may damage the mechanism.
Do not force the tray by hand during the opening and closing operations.
To avoid dirt and dust entering the mechanism, keep the disc tray
closed.
If the Compact Disc is seriously scratched or too dirty the player may not
be able to read it or play it.
Never load more than one disc into the disc tray at one time.
8
Normal d d isc p p lay
1. Switch on your amplifier and set its input selector to the correct
position. Adjust the volume control to a minimum.
2. Press the On/Standby switch.
3. Press the Open/Close button to open the disc tray, and load a disc.
4. Press the Open/Close button again to close the tray. The CD player
will read the disc and enter standby mode. Alternatively pressing Play
will close the tray and start playing the disc.
5. Press the Play button. The disc will start playing from the beginning
of the first track. When the last track has finished playing, the CD
player will return to standby mode.
6. To stop the disc at any point press the Stop button. Pressing the Play
button while the disc is playing will pause the disc. When the disc is
paused the display will flash, play can be resumed by pressing the
PLAY button again.
Locating a a s s pecific t t rack
1. Ensure that a disc is loaded and the player is in stopped mode.
2. Pressing the Skip/Scan Right button once will forward the CD by one
track. Repeat as necessary.
3. Press Play. The disc will play to the end of the disc and then return to
standby mode.
4. Pressing the Skip/Scan Left button will access the previous track.
During play, pressing reverse will firstly rewind the track playing.
Pressing again will then access the previous track.