Installing Abrasive Disc; Operation - Makita PV301D Instruction Manual

Remove all dirt and foreign matter from the hook-and-
loop system of a pad and backing pad. Attach the pad to
the backing pad so that their edges are aligned.
To remove the pad from the backing pad, just pull up
from its edge.
1
2
► 1. Pad 2. Backing pad

Installing abrasive disc

Optional accessory
CAUTION:
Only use the twist-on/twist-off
system discs for sanding.
Disc selection
CAUTION:
The outside diameter of accessory
must be within the capacity rating of the power
tool.
CAUTION:
The rated speed of accessory
must be equal or higher than the maximum speed
marked on the power tool.
Always use the correct sized wheel that is made from
appropriate abrasive materials with the right grit size for
your job.
Abrasive disc materials
Abrasive materials Basic features
Aluminum Oxide Best for steel,
stainless steel
and metals. Single
crystal abrasive
material with
high tenacity and
durability.
Alumina Zirconium Best for INOX and
metals. Extremely
sharp and hard
abrasive material
with high durability.
Ceramic Best for INOX,
metals and non-fer-
rous materials.
Extremely sharp
and high resistant
to shock/heat/
wear.
Grit size
Grit
24/36 (coarse)
60/80
120 (fine)
Installing and removing abrasive disc
secured properly. Loose attachment will run out of
balance and cause an excessive vibration which may
cause loss of control.
Remove all dirt and foreign matter from the backing
pad. Thread an abrasive disc onto the backing pad
while pressing in the shaft lock. Hand tighten securely.
To remove the disc from the backing pad, follow the
installation procedure in reverse.
► 1. Abrasive disc 2. Backing pad

OPERATION

polishing.
Practical
applications
disc for sanding (optional accessories).
Fast sanding
Most metal jobs
and stable. Falling object may cause personal injury.
on the switch handle and the other hand on the
side grip when performing the tool.
Removing paint
from cars and
an extended time period. It may result in tool malfunction
boats, etc.
which causes electric shock, fire and/or serious injury.
General metal work
that the side grip or caps are not loose. If the side grip or
caps are loose, the front cover may fall and cause an injury.
10 ENGLISH
CAUTION:
Make sure that the backing pad is
1
2
CAUTION:
Only use Makita genuine pads for
CAUTION:
Only use Makita genuine abrasive
CAUTION:
Make sure the work material is secured
CAUTION:
Hold the tool firmly with one hand
CAUTION:
Do not run the tool at high load over
CAUTION:
Be careful not to touch the rotating part.
CAUTION:
Before operating the tool, make sure
Practical applications
Heavy stock removal
Medium stock removal
Finishing