Philips SBC SC466 Manual page 5

ENGLISH
6
Using batteries
Operating the Baby unit cordlessly
I
1
Charge the batteries for at least 14 hours
Remove the power adapter from the Baby unit power socket
Use the Baby unit cordlessly for up to 10 hours
2
> if the power light flashes red, recharge the batteries
Replacing the battery packs
1
Open the Baby unit's battery compartment cover.
2
Open the Parent unit's battery compartment cover .
Disconnect the old battery pack from the power plug and remove.
3
Carefully connect the new battery pack to the power plug and place
inside the battery compartment.
4
Close battery compartment cover.
Batteries
Dispose of used batteries in an environmentally friendly manner.
Do not mix old and new batteries, or different types of batteries.
Technical specifications
Power supply:
Technical specifications
Battery pack; rechargeable NiMH for Parent and Baby unit (included);
Power supply: •
• AC power adapter 230V AC, 50 Hz (two included): - Output voltage 9V DC, 200mA.
• Only use the AC power adapter included
Operating range: • up to 250 metres in ideal conditions (walls, floors, etc. can limit this distance.)
-10°C to 40°C
Operating temperature: •
Digital Pilot tone: • Continuous communication link (hidden signal helps reduce interference and ensures a
continuous link between both units so you only hear your baby's sounds).
SBC SC466/00:
Transmission frequencies:
I
All manuals and user guides at all-guides.com
from 40.695 to 40.675 MHz
Problem solving
Problem Possible cause
Power light does not P P P P P arent unit: arent unit: arent unit: arent unit: unit is not turned on. arent unit:
light.
Batteries are low.
Bab Bab y unit: y unit:
Bab Baby unit: Bab y unit: y unit: unit is not turned on.
Power adapter is not plugged in or
batteries are low.
High pitched noise. Units are too close together.
Batteries
Battery life is at an end.
do not charge.
No sound. Volume on parent unit is set too
low.
Power light flashing. Batteries are low
Interference or poor Mobile or cordless phones too close
reception. to the baby monitor.
Pick-up from another Both systems are operating on the
baby monitor. same frequency.
System check light Units are out of range or there is
flashing (red) / interference from another FM
System check alarm. source.
ENGLISH
7
Solution
Turn VOLUME ON/OFF control
downwards.
Recharge batteries.
Push power button.
Plug in power adapter or recharge
batteries.
Move parent unit away from baby
unit. Turn VOLUME ON/OFF
control on parent unit upwards.
Connect charging base to mains
power. Replace battery pack.
Turn VOLUME ON/OFF control
downwards.
Recharge the battery packs
Move phones away from the units.
Switch channels.
Move units closer together to
restore the link. Remove the other
FM source.