Advertisement
STEP 4 (See Diagram 4)
A.) Attach the Leg Developer (#11) to the Front Post (#3). Secure it with an Axle (#43), two
M10 x 3/4" Allen Bolts (#52) and two ¾" Washers (#44).
B.) Insert two Foam Tubes (#20) halfway through the holes on the Leg Developer. Push four
Foam Rolls (#27) onto the Tubes from both ends. Plug four Foam Roll End Caps (#28)
into the ends.
C.) Insert the Long Foam Tubes (#12) halfway through the holes on the Front Post (#3). Push
two Foam Rolls (#27) onto the Tubes from both ends. Plug two Foam Roll End Caps (#28)
into the ends.
D.) Slide an Olympic Sleeve (#26) onto the weight post on the Leg Developer. Attach a Spring
Clip (#42) to the Sleeve.
©IMPEX
9
DIAGRAM 4
www.marcypro.com
Advertisement
