FUNAI TD6D-D500GB Owner's Manual page 21

Note
If you have a standard TV:
• Select "4:3 Letter Box" for a full width picture with black
bars at the top and bottom.
• Select "4:3 Pan & Scan" for a full height picture with both
sides trimmed.
If you have a wide screen TV:
• Select "16:9 Wide".
Channel Setting
You can retune this unit or edit the channel setting with
following methods.
Auto Tuning (DVB & ANALOG)
DVB ANALOG
Programme the tuner to scan both analogue and DVB
channels you can receive in your area.
1
In stop mode, press [SETUP]. Select "General
Setting" using [K \ L], then press [ENTER\OK].
"General Setting" menu will appear.
2 Select "Channel" using [K \ L], then press
[ENTER\OK].
3
Select "Auto Tuning (DVB & ANALOG)" using
[K \ L], then press [ENTER\OK].
The unit will start storing channels available in your area.
General Setting
Playback
Display Country
Video Auto Tuning (DVB & ANALOG)
Recording DVB Channel Setup
Clock ANALOG Channel Setup
Channel
DivX
HDMI
DVB Setting
Reset All
Wait for several minutes to finish channel storing.
4
Press [SETUP] to exit.
You can select only the channels memorised in this unit
by using [PROG. G \ H].
To cancel auto tuning
Press [SETUP] during scanning.
Note
• The number of TV channels you can get is different depends
on your local area.
• If the auto tuning is cancelled during scanning, some
channels not yet tuned may not be received.
Auto Tuning (ANALOG)
ANALOG
Programme the tuner to scan only the analogue channels you
can receive in your area.
1
In stop mode, press [SETUP]. Select "General
Setting" using [K \ L], then press [ENTER\OK].
2
Select "Channel" using [K \ L], then press
[ENTER\OK].
3
Select "ANALOG Channel Setup" using [K \ L],
then press [ENTER\OK].
4
Select "Auto Tuning" using [K \ L], then press
[ENTER\OK].
The unit will start storing channels available in your area.
ANALOG Channel Setup
Auto Tuning
Manual Tuning
Move
Wait for several minutes to finish channel storing.
5
Press [SETUP] to exit.
You can select only the channels memorised in this unit
by using [PROG. G \ H].
To cancel auto tuning
Press [SETUP] during scanning.
Note
• The number of TV channels you can get is different depends
on your local area.
• If the auto tuning is cancelled during scanning, some
channels not yet tuned may not be received.
• When "Country" setting is set to "France", sorting of TV
channels from 1 to 6 will be performed automatically as
follows.
1: TF1 2: F2
4: CANAL+ 5: F5/ARTE
Manual Tuning (ANALOG)
ANALOG
You can preset an analogue channel manually and
individually.
1
In stop mode, press [SETUP]. Select "General
Setting" using [K \ L], then press [ENTER\OK].
2
Select "Channel" using [K \ L], then press
[ENTER\OK].
3
Select "ANALOG Channel Setup" using [K \ L],
then press [ENTER\OK].
4
Select "Manual Tuning" using [K \ L], then
press [ENTER\OK].
5
Select "Position" using [K \ L], then press [1].
Position
System
Channel
Decoder
Skip
3: F3
6: M6
1
L
1
OFF
ON
21
EN