Periodic Maintenace
Brush Roll
The brush roll turns as it sweeps and combs the carpet nap.
Remove hair and threads from the brush roll so it continues
brushing the carpet. To maintain the most efficient cleaning,
the bristles must touch the carpet. To test the bristle length,
hold a ruler against the underneath side of the cleaner. If the
bristles no longer touch the ruler, replace the brush roll.
Brush Roll Belt
The brush roll belt turns the brush roll to agitate, sweep, and
comb the carpet nap. Cut away any hair or threads wound
around the brush roll because the buildup could cause the belt
to rotate unevenly. The special cog belt should seldom need
replacement. If an unusual circumstance causes belt damage,
call 1-800-282-2886 for nearest Warranty Repair Center.
How To Replace Brush Roll
CAUTION: Turn off the switch and unplug the
electrical cord. Belt pulleys can become
hot during normal use.To prevent injury,
avoid touching the motor shaft.
1. Lower handle to floor. Flip cleaner over.
2. Remove the six screws indicated above with a screwdriver.
One screw is hidden below the wheel carriage. Lift the
wheel carriage in order to reach it.
3. Flip the cleaner back over and lift hood to remove.
NOTE: The carpet height adjustment has to be in
the lowest or highest position to remove or
reinstall the hood.
8
(continued)
4. Lift left end of brush roll.
5. Remove and discard old brush roll.
6. Place new belt around motor shaft.
7. Place belt around the pully of the new brush roll.
8. Align left end cap with base. Push end cap securely into
9. Push right end cap into base until it snaps into place.
IMPORTANT
10
11. Place hood back on cleaner. Replace six screws.
12. Tighten screws.
4
8
place.
Rotate brush roll by hand two full rotations
.
to properly position belt.
Motor
5
Shaft
Belt
Brush
Roll
6
7
9