Assemble; Attach Handle; Attach Hose - Eureka Boss 4D 5892BVZ Owner's Manual

How to Assemble
CAUTION: Assemble the cleaner before using.
Unit has moving parts, make sure on/
off switch is in off (0) position before
plugging in.
NOTE: Features may vary by model yet all parts
assemble the same.

Attach Handle

CAUTION: Use special care. Do not pinch electrical
cord between handle and cleaner.
2
1. From rear of cleaner, align handle with groove and slide
onto cleaner. If necessary, use thumb and finger pressure
to slide handle into position.
2. Attach handle with the two 1 inch screws provided in
the assembly packet. Use a Phillips
Guide excess cord though the hole located in the handle
while assembling handle.
NOTE: Hand tighten with screwdriver to be sure
both screws are firmly seated.

Attach Hose

3. Pick up hose and lay across upper hose support.
4. Push the end of the hose in the lower hose retainer to
secure.
4
1
Electrical Grooves
Cord
head screwdriver.
®
Upper Hose
Support
3
4
Hose
Lower Hose Retainer
Store Hose and Accessories
Dusting
Brush
Store Electrical Cord
5. You will find your cord retainer on the handle above the
upper cord hook. Firmly push the electrical cord down
into the cord retainer. This will place the cord out of the
way when you vacuum.
6. Next wind the cord around the two cord hooks on the
back side of cleaner.
7. Secure the plug to the cord to prevent unwinding.
Nested Wands
5
Cord Retainer
6
Cord Hook
7 Plug
6
Cord Hook