How to replace brush roll or belt
1
Remove 4 screws from brush
roll cover. Lift off cover using
rear tabs.
4
Remove belt from motor
shaft and brush roll.
7
Replace the white latch assembly
back into position.
12
Eureka Customer Service HELPLINE 1-800-282-2886
2
Use a Phillips screwdriver to
remove 2 screws.
5
Replace belt around
motor shaft.
8
Reinstall 2 screws.
3
Pull up white latch to release the belt
assembly and lift straight out.
6
Insert left end of brush roll first. Loop
new belt around right end of brush roll
and insert right end cap into base.
Scan for belt
replacement
instructions.
9
Replace brush roll cover
and 4 screws.
www.eureka.com