Re-Setup Of Servo Program - JUKI DP-2100 Engineer's Manual

(4) Re-setup of servo program

Perform the work by the procedure below when rewriting the servo program in the same way of "Re-setup of
main program".
1. When main program matches with servo program
Perform the work by the procedure below when making the servo program version-up by using the smart
media card.
1) First, turn ON the power. Normally, the sewing ready screen is displayed.
2) Insert the smart media card into the operation panel.
3) Perform operation by the procedure displayed in the screen below.
Data edit screen
1) Press key
Communication screen 1
2) Press key .
3) Press key .
Data selection screen
4) Press key
5) Press key
d
– 65 –
for three seconds.
.
.