Table of Contents
Advertisement
Use a Philips-head screwdriver to tighten 4pcs
screws for locking the rear cover with the assembled
S18
unit. Paste 2pcs labels on the specific positions.
(No.1~4 screw size=M4x10; Torque=9
2
4
Take a stand close to the monitor. Fit the two tabs on
the upper part of the stand into the grooves on the
S19
back of the monitor, and then lower the stand so that
the monitor mounting area snaps onto the stand.
Take 1pcs base, assemble the base with the stand,
S20
then use
a screwdriver to tighten the detached screw
clockwise for locking the stand with base.
Lift up the monitor to checking the gap between the
front bezel with panel module , then provide power
S21
supply and a video signal to the monitor
the monitor for functionality check.
4. Disassembly and Assembly Procedures
0.5kgfxcm)
±
3
1
, then turn on
Advertisement
Table of Contents
