Installing The Mount On The Mounting Bracket - Garmin MONTANA 600 Series Instructions Manual

1. Separate the swivel base
2. Using the swivel base as a template, mark the pilot hole
locations .
➋
3. Drill the mounting holes.
• If you secure the base with machine bolts, drill three
5/32 in. (5 mm) holes at the locations you marked.
• If you secure the base with self-tapping screws,
drill three 1/16 in. (1.5 mm) starter holes at the
locations you marked. Do not make the starter
holes deeper than half of the screw length.
4. Secure the swivel base with 3 bolts or 3 screws
(not included).
5. Place the swivel mount bracket
base and secure it with the short knob

installing the Mount on the Mounting Bracket

1. Align the slot
long mounting knob
on the bar.
If necessary, you can adjust the knob to spread the
bracket arms apart. Turn the knob counter-clockwise
to widen the bracket arms, turn the knob clockwise
to tighten the bracket arms.
4
from the mount.
➊
on the back of the cradle with the
➊
and slide the cradle into place
➋
➌
over the swivel
➍
.
➎
Montana 600 Series Marine Mount Instructions
➊
➋
➎
➍
➌
➊
➋