Bail Mount Instructions - Garmin Bail Mounting Instructions

Bail Mount Instructions

See the Important Safety and Product Information guide in the
GPS device product box for product warnings and other
important information.
Garmin strongly recommends having an experienced installer
®
with the proper knowledge of electrical systems install the
device. Incorrectly wiring the power cable can result in damage
to the vehicle or the battery and can cause bodily injury.
Always wear safety goggles, ear protection, and a dust mask
when drilling, cutting, or sanding.
The metal contacts on the GPS device and the mount should be
kept dry to avoid equipment damage. Use the weather cap on
the mount at all times when the unit is not mounted to keep the
metal contacts dry and protected.
To obtain the best performance and to avoid damage to your
boat, install the device according to these instructions.
Read all installation instructions before proceeding with the
installation. If you experience difficulty during the installation,
contact Garmin Product Support.
Tools Needed
• Drill
• Phillips screwdriver
3
• 9.5 mm ( / in.) wrench or socket
8
• 3 bolts or 3 screws:
◦ #8 (4 mm) pan-head machine bolts with nuts and
washers, and a 5 mm (
◦ #8 (4 mm) pan-head self-tapping screws and a 1.5 mm
1
( / in.) drill bit
16
Mounting Considerations
The swivel base must be mounted using pan-head machine
bolts or self-tapping screws. Using screws with countersunk
heads can damage the mounting bracket.
The device should be mounted in a location that provides a clear
view of the screen and is easy to reach.
The device should be mounted in a location that is sturdy
enough to support the mount and device.
The device must be mounted in a location that allows room to
route and connect the cables. You should allow at least 8 cm
(3 in.) of clearance behind the case.
Mounting the Bracket Assembly
1
Separate the swivel base
2
Using the swivel base as a template, mark the pilot hole
locations .
3
Select an option:
• If you intend to secure the base with machine bolts, drill
5
three 5 mm ( / in.) holes.
32
2
WARNING
CAUTION
NOTICE
5
/ in.) drill bit
32
NOTICE
from the mount.
• If you intend to secure the base with self-tapping screws,
1
drill three 1.5 mm ( /
NOTE: Do not make the holes deeper than half of the
screw length.
4
Secure the swivel base with the bolts or screws
5 Place the swivel mount bracket
secure it with the short knob
Installing the Mount on the Mounting Bracket
1
Align the slot on the back of the cradle with the long
mounting knob , and slide the cradle into place on the bar.
NOTE: You can turn the long mounting knob to adjust the
width of the bracket arms.
2
Adjust the angle of the cradle, and tighten the long mounting
knob until the cradle
3
Rotate the swivel mount bracket
angle, and tighten the knob.
The bracket clicks as you turn it.
Connecting Power to the Mount
1
Select a mounting location based on available power
sources, safe cable routing, and an unobstructed view.
2 Connect the cables.
in.) starter holes.
16
over the swivel base and
.
is secure.
to an optimal viewing
Installation Instructions
.