Controls - GE AHL24 Owner's Manual And Installation Instructions

About the controls on the air conditioner
Features and appearance will vary.
Lights next to the touch pads on the air conditioner control panel indicate the selected settings.
Auto
Cool
Fan Only
High
Energy Saver
Med
Low
Air Conditioner Controls

Controls

Power Pad
Turns air conditioner on and off. When turned
on, the display will show the room temperature.
Display
Shows the room temperature or time remaining
on the Delay timer. Shows the Set temperature
while setting the temperature in Cool or Energy
Saver modes. The Set light will turn on while
setting.
Temp and Delay Increase
Pads
Use to set temperature or delay time.
Temperature can be set in Cool and Energy
Saving and mode.
Mode Pad
Use to set the air conditioner to Fan Only or
Cool, Energy Saver mode.
Fan Speed Pads
In Cool, Energy Saving mode:
Use to set the fan speed to Auto, High, Med or
Low on the unit.
In Fan Only mode:
Use to set the fan speed to High, Med, or Low
on the unit.
Reset Filter
LED will turn on when fan has accumluated 250
hours of run time as a reminder to clean filter.
Press Reset Filter to turn off the LED and reset
the accumulated run time.
4
On
Off
/Decrease
▲
Unit power
on/off
Mode select
Fan speed
Delay 1–24hr
Temperature
set/Delay
Timer Increase
and Decrease
Remote Control
Delay Pad
When the air conditioner is off, it can
be set to automatically come on in 1 to 24 hours
at its previous mode and fan settings.
When the air conditioner is on,
it can be set to automatically turn off in 1 to
24 hours.
How to set:
Press the Delay 1–24hr pad on the unit or the
▼
remote control. Each touch of the Increase ▲ /
Decrease ▼ pads on the unit or the Increase
–
/ Decrease pads on the remote control will set
the timer in 1-hour intervals.
To review the remaining time on the Delay
1–24hr timer, press the Delay 1–24hr pad on the
unit or the remote control. Use the Increase ▲ /
Decrease ▼ pads on the unit or the Increase
–
/ Decrease pads on the remote control to set
a new time if desired.
To cancel the timer, press Decrease
the unit or the remote control until the set time
is zero. After 3 seconds the light on the Delay
1-24 hour pad goes off.
+
+
pad on