GE AHL24 Owner's Manual And Installation Instructions page 5

Do Not Operate in Freezing Outdoor Conditions
This cool-only air conditioner was not designed for
freezing outdoor conditions. It must not be used in
freezing outdoor conditions.
Remote Control
To ensure proper operation, aim the remote
control at the signal receiver on the air
conditioner.
The remote control signal has a range of
up to 20 feet.
Cool Mode
Use the Cool mode at Low, Med, High or Auto
Speed for cooling. Use the Temperature Increase
+ / Decrease – pads to set the desired temperature
between 64°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the room
temperature. The compressor will cycle on
and off to keep the room at the set level of comfort.
Set the thermostat at a lower number and the indoor
air will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned on
while set to a Cool setting or if turned from a fan
setting to a Cool setting, it may take approximately
3 minutes for the compressor to start and cooling to
begin.
Energy Saver Mode
Energy Saver mode conserves energy by optimizing
the cooling power of your air conditioner. Once the
desired temperature is reached, the fan will turn off to
save energy.
The fan will periodically turn back on to ensure that all
cooling capacity in the unit is used. This is the default
setting for all Energy Star air conditioners, and they
are intended
to operate this way. In addition, each time the unit is
powered down, it will re-start in Energy Saver mode.
This includes if the unit turns back on by the Time
Delay On/Off mode.
Fan Only Mode
Use the Fan Only Mode at Low, Med or High fan
speed to provide air circulation and filtering without
cooling. Since fan-only settings do not provide
Auto Fan
Set to Auto for the fan speed to automatically set
to the speed needed to provide optimum comfort
settings with the set temperature.
Make sure nothing is between the air conditioner
and the remote control that could block the
signal.
Make sure battery is fresh and installed correctly
as indicated on the remote control.
Cooling Descriptions
For Normal Cooling
High or Med fan with a middle set temperature.
For Maximum Cooling
and High fan with a lower set temperature.
For Quieter and Nighttime Cooling
Cool mode and Low fan with a middle set
temperature.
When Energy Saver mode is ON:
It is normal for the fan to cycle "Off" and then back
"On" in this mode. This on/off cycle can repeat
multiple times. Because the fan will cycle off, you may
notice a variation in room temperature and humidity.
When Energy Saver mode is OFF:
The fan will run continuously, and in Cool mode the
compressor will cycle on and off to maintain room
temperature.
To override Energy Saver mode, toggle the "Mode"
button from "Energy Saver" to "Fan" or "Cool" settings.
cooling, a Set temperature cannot be entered. The
room temperature will appear in the display.
If the room needs more cooling, the fan speed
will automatically increase. If the room needs less
cooling, the fan speed will automatically decrease.
GEAppliances.com
Cool mode and
Cool mode
5