Aiwa XR-X7 Operating Instructions Manual page 17

Timer playback
Turns on the unit at a specified time for the specified duration.
Make sure the clock is set correctly.
1 Select the desired playback source.
2 On the main unit
1 Press MODE repeatedly so that "
displayed.
2 Within 7 seconds, turn VOLUME/MULTI JOG
so that " PLAY" is displayed.
On the remote control
Hold down SHIFT and press TIMER.
"5" indicator lights up and " PLAY" appears on the
display. The timer-on time and the source name along
with the timer-activated duration appear alternately on the
display.
3 Within 7 seconds, press ENTER (a on the remote
control).
"5" lights up. The timer-on time and the source name
along with the timer-activated duration appear alternately
on the display.
4 Press f or g to set the timer-on time, then
press ENTER or a.
5 Press f or g to set the timer-activated
duration, then press ENTER or a.
With each press, the timer-activated duration changes in
5-minute steps between 5 to 240 minutes.
If there is no button input for 4 seconds, the current setting
is entered automatically.
•VOLUME/MULTI JOG is also available in place of f
or g.
6 Adjust the volume and tone for timer playback.
If the volume level is set to 21 or higher, it is automatically
turned down to 20 when the unit is turned on by the timer.
7 Prepare the source.
To play CD, insert a disc.
To play the radio, select the band and tune in the desired
station.
" is
To play external equipment connected to the
VIDEO/AUX IN jacks, set an external timer for the
equipment so that playback begins at the same time.
8 Press POWER to turn the unit off.
"5" remains on the display to indicate the timer standby
mode (when ECO mode is deactivated).
At timer-on time, the unit turns on and plays the selected
source. After the specified timer-activated duration, the
unit turns off again.
•Timer playback will not begin unless the unit is turned off
first.
•Connected equipment cannot be turned on or off by the built-
in timer of this unit. Use an external timer.
To check the timer setting
Hold down SHIFT and press TIMER.
The timer-on time, the source and the timer-activated duration
are displayed for 7 seconds.
To change the timer setting
Reset the timer again.
To turn off the timer
On the main unit
Press MODE to display " PLAY" and turn
VOLUME/MULTI JOG so that " OFF" is displayed. Then
press ENTER. "5" disappears from the display.
On the remote control
Hold down SHIFT and press TIMER repeatedly until
" OFF" is displayed. "5" disappears from the display.
Tip:
Your timer setting is retained even if the timer is turned off.
Next time the timer is turned on, you can change your previous
setting, or simply use the same setting again.
En
17