Panel Ports & Buttons; Reset Button - ZyXEL Communications PM7300-T0 User Manual

Table 2 PM7300-T0 LED Behavior (continued)
LED
PON
LOS
10GbE
2.1.2 Panel Ports & Buttons
Figure 3 Side Panel
The following table describes the items on the rear panel.
Table 3 Panel Ports and Buttons
LABELS
RESET
PON
10GbE
POWER
ON/OFF

2.1.3 RESET Button

Insert a thin object into the RESET hole of the PM7300-T0 to reload the factory-default configuration file if
you forget your password or IP address, or you cannot access the Web Configurator. This means that
you will lose all configurations that you had previously saved. The password will be reset to the default
(see the PM7300-T0 label) and the IP address will be reset to 192.168.0.1.
Chapter 2 Hardware
COLOR STATUS
Green On
Blinking
Off
Red On
Blinking
Off
Green On
Blinking
Off
DESCRIPTION
Press for 5 seconds to restore the PM7300-T0 to its factory default settings.
Connect the PM7300-T0 to the Internet using a fiber cable.
Connect the PM7300-T0 to an Ethernet device such as a network switch, NAS or server. Connect a
computer for initial configuration.
Connect the power adapter and press the POWER button to start the PM7300-T0.
Press the ON/OFF button after connecting the power adapter to start the PM7300-T0.
PM7300-T0 User's Guide
DESCRIPTION
The PON connection is ready.
The PM7300-T0 is trying to establish a link.
The fiber link is down.
PON transceiver is powered down.
This is a R(x) low power alarm.
The PON connection is working normally.
The Ethernet link is up.
The PM7300-T0 is transmitting or receiving data.
The Ethernet link is down.
12