Advertisement
Operating Manual Reprint
Controls & Connectors
Controls & Connectors
Controls & Connectors
Controls & Connectors
Controls & Connectors
LED Indicator
Glows Green
Monitor on (except 5-Tone Mode)
Blinking Green Busy Channel (or SQL off)
Glows Red
Transmitting
Blinking Red
Battery Voltage is low
Blinking Yellow Receiving a Selective Call
Antenna
Push To Talk
( PTT ) Switch
Monitor Button
Microphone
Battery Pack Latch
Display Icons & Indicators (VX-180E Only)
Display Icons & Indicators (VX-180E Only)
Display Icons & Indicators (VX-180E Only)
Display Icons & Indicators (VX-180E Only)
Display Icons & Indicators (VX-180E Only)
This indicator confirms that
D
W
UAL
ATCH
This icon is the "Low Battery" in-
dicator, which appears when the
battery voltage becomes too low
for proper operation.
This indicator confirms that 2
or 5-T
D
is active.
ONE
ECODE
8 Character Alpha-numeric Invertible Display
2
All manuals and user guides at all-guides.com
CH ( Channel ) Selector
VOL/PWR Knob
MIC/SP Jack
( External Mic/Earphone )
Speaker
LCD
(VX-180E)
Soft KEY
(VX-180E)
is active.
This indicator confirms that
this channel will be skipped
during scan.
This indicator will ap-
pears during this "Scan
Pause" condision.
Before You Begin
Before You Begin
Before You Begin
Before You Begin
Before You Begin
Battery Pack Installation and Removal
To install the battery, hold the transceiver with your
left hand, so your palm is over the speaker and your
thumb is on the top of the belt clip. Insert the battery
pack into the battery compartment on the back of the
radio while tilting the Belt Clip outward, then close
the Battery Pack Latch until it locks in place with a
"Click."
To remove the battery, turn the radio off and remove
any protective cases. Open the Battery Pack latch on
the bottom of the radio, then slide the battery down-
ward and out from the radio while holding the Belt
Clip.
Caution!
Do not attempt to open any of the rechargeable Ni-
Cd packs, as they could explode if accidentally short-
circuited.
Low Battery Indication
As the battery discharges during use, the voltage gradu-
ally becomes lower. When the battery voltage becomes
to low, substitute a freshly charged battery and recharge
the depleted pack. The TX/BUSY indicator on the top
of the radio will blink red (on the VX-180, the "
icon will appear on the LCD) when the battery voltage
is low.
Avoid recharging Ni-Cd batteries often with little use
between charges, as this can degrade the charge capac-
ity. We recommend that you carry an extra, fully-
charged pack with you so the operational battery may
be used until depletion (this "deep cycling" technique
promotes better long-term battery capacity).
"
Advertisement
