Equipments Connection - 3M X90w Manual

2. Equipment connection and network setting
2.2 Network connection using "One-Click-Communication" function
(Continued)
4) Click "One-Click" button in fig. 2.2.a. Projector is found. Then capture start
button is pushed and real time display is started automatically.
[Wireless LAN connection]
1) When projector network settings such as IP address and subnet mask are
changed, need to return to the projector factory default settings. (9)
2) In case 802.11b/g wireless LAN device is built-in the PC, make the LAN valid
and other network connections invalid. If wireless LAN device is not built in the
PC, connect 802.11b/g wireless LAN device and install device driver to the PC.
(Refer to the user guide for wireless LAN device details.)
3) Start up "MIU Live Viewer", then the window appears (shown in fig. 2.2.a).
4) Click "One-Click" button as shown in fig. 2.2.a. Then projector will be found
and the capture start button
automatically.
2.3 Manual network connection setting – Wired LAN -
When you need to set the original IP address and SSID other than factory default
settings, need to set up network connection manually.
This section explains how to set up network connection manually.

2.3.1. Equipments connection

At first, connecting projector and PC with wired LAN connection to check PC
setting and connection. Next section explains PC settings.
Connecting projector with network using LAN cable, and then set it ready to
communicate with PC.
* Connecting with existing network, contact network administrator.
At last, turn on the projector. This is the end of Equipments connection.
10
is activated then real time display is started