Table of Contents
Advertisement
KEY
N Cylinder Air Inlet: accepts 1/4 in. (6.3 mm) O.D. tubing
P Atomization Air Inlet: 3/8 in, (9.5 mm) O.D. tubing
R Fan Air Inlet: 3/8 in. (9.5 mm) O.D. tubing
S Fluid Inlet: 1/4 npsm
T Fluid Outlet (circulating gun only): 1/4 npsm
Side Mounted Manifold Ports
T (or S)
FAN
R
Bottom Mounted Manifold Ports
R
FAN
T (or S)
F
. 8: Manifold Ports
IG
313516F
N
S (or T)
ATOM
CYL
ti8096a
P
N
P
ATOM
CYL
S (or T)
ti8097a
Flush Spray Gun
Before running any paint through the spray
gun:
1. Flush the gun with a solvent that is compat-
ible with the fluid to be sprayed, using the
lowest possible fluid pressure and a
grounded metal container.
2. Perform Pressure Relief Procedure; see
page 18.
Position Air Cap
Air caps are factory-set with the alignment pin
(A) set to a vertical spray pattern. To change
the air cap to a horizontal spray pattern, use a
1/6 in. hex wrench to unscrew the alignment
pin (A) and relocate it to the horizontal spray
pattern hole. When relocating the pin use low
strength thread locker. Torque to 1.5-2.5 in-lb
(0.2-0.3 N•m). Do not overtighten. Refer to
F
. 9.
IG
A
F
. 9: Position Air Cap
IG
ti8171a
Vertical Pattern
Horizontal Pattern
ti8172a
Setup
ti8170a
15
Advertisement
Table of Contents
