Table of Contents
Advertisement
Installation
Mount Gun
Reciprocating Arm Rod Mount
To mount the gun on a reciprocating arm rod
[0.5 in. (13 mm) diameter maximum]:
1. Insert the mounting bar (A) through the
hole in the manifold as shown in F
NOTE: Use the 1/8 in. alignment pin (P) to
assist in orienting the gun.
2. Secure the gun to the bar by tightening the
mounting screw (B).
B
P
A
F
. 3: Reciprocating Arm Mount
IG
12
Stationary Support
To mount the gun on a stationary support
(refer to F
hole layout for your manifold, pages 38-42):
1. Align the manifold with the alignment pins.
Locate alignment pins and holes per the
. 3.
IG
mounting hole layout.
2. Secure the gun to the support with two M5
x 0.8 capscrews (C). The screws must be
long enough to engage the threaded holes
in the gun manifold to a depth of 1/4 in.
(6 mm).
ti13587a
F
. 4: Stationary Support Mount
IG
. 4 and to the correct mounting
IG
C
ti13588a
313516F
Advertisement
Table of Contents
