Epson EX100 User Manual page 63

4. Loosen the lamp cover screw (you don't need to remove it). Then
slide the lamp cover to the side and lift it off of the projector.
5. Loosen the two screws holding the lamp in place (you can't
remove them).
6. Hold the lamp as shown and pull it straight out.
7. Gently insert the new lamp. (If it doesn't fit easily, make sure it is
facing the right way.)
Loosen, but don't
remove these screws
Maintaining the Projector
note
The lamp(s) in this
product contain mercury.
Please consult your state and
local regulations regarding
disposal or recycling. Do not
put in the trash.
63