Epson EX100 Quick Setup

EX100
Quick Setup
Connect the projector
to your notebook
Before using the projector, make sure you read the safety instructions in
the User´s Guide on your projector CD.
1
Locate the required cables:
Power cord
2
Connect the computer cable to the blue Computer/Component Video
port on the projector.
3
Connect the other end to your notebook's video-out
or monitor port.
4
Connect the power cord to the projector, then plug the other end
into an electrical outlet.
Turn on your equipment
1
Turn on your notebook.
2
Open the A/V Mute slide (lens cover).
NOTE: The slide must be opened completely.
*411491900*
*411491900*
Follow these instructions to connect
the projector to your notebook. For
other setup options, such as using the
included VGA-to-Component Video
adapter, see your User's Guide.
VGA computer cable
3
Make sure the Power light is orange and not flashing.
Power light
Power button
4
Press the Power button to turn on the projector.
CAUTION: Before unplugging the projector...
Shut down the projector properly:
1. Press the Power button twice.
2. When the orange light stops flashing and the projector beeps,
you can unplug the projector.

Adjust the image

1
If you've turned on your notebook and you don't see an image,
press the Source Search button on the projector or remote control
to select the image source.
NOTE: If you still see a blank screen or have other display problems,
see the troubleshooting tips on the back of this sheet.
2
To raise the image, press the blue foot release button for the front
adjustable foot and lift the front. Release the button to lock the foot
in position.
3
Turn the focus ring to sharpen the image.
Turn the zoom ring to reduce or enlarge the image.
Focus
Zoom
4
If your image looks like or
to one side of the screen at an angle. Place it directly in front of the
center of the screen, facing the screen squarely.
5
If your image looks like or
on the projector to correct it.
Turn over
, you've placed the projector off
, press the or buttons