Panasonic KX-TG7921E Operating Instructions Manual page 39

Remote access code
A 3-digit remote access code must be entered
when operating the answering system
remotely. This code prevents unauthorised
parties from listening to your messages
remotely.
Important:
R In order to operate the answering system
remotely, you must first set a remote
access code.
1
M N (right soft key) #306
2
To turn on remote operation, enter the
desired 3-digit remote access code.
3
MOKN a MeN
Deactivating remote operation
Press * in step 2 on "Remote access code"
page 39.
R The entered remote access code is deleted.
Using the answering system
remotely
1
Dial your phone number from a
touch-tone phone.
2
After the greeting message starts, enter
your remote access code.
3
Follow the voice guidance prompts as
necessary or control the unit using
remote commands (page 39).
4
When finished, hang up.
Voice guidance
During remote operation, the unit's voice
guidance starts and prompts you to press 1
to perform a specific operation, or press 2 to
listen to more available operations.
Note:
R If you do not press any dial keys within 10
seconds after a voice guidance prompt, the
unit disconnects your call.
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
TG78xx_79xxE(en)_0407_ver112.pdf 39
Answering System
Remote commands
You can press dial keys to access certain
answering system functions without waiting for
the voice guidance to prompt you.
Key Operation
1 Repeat message
(during playback)
2 Skip message
(during playback)
4 Play new messages
5 Play all messages
6 Play greeting message
7 Record greeting message
9 Stop recording
Stop playback
0 Turn answering system off
*4 Erase currently playing message
*5 Erase all messages
*6 Reset to a pre-recorded greeting
message (during greeting
message playback)
*# End remote operation
(or hang up)
*1 If pressed within the first 5 seconds of a
message, the previous message is
played.
Turning on the answering system
remotely
If the answering system is off, you can turn it
on remotely.
1
Dial your phone number from a
touch-tone phone.
2
Let the phone ring 20 times.
R A long beep is heard.
3
Enter your remote access code within 10
seconds after the long beep.
R The greeting message is played back.
R You can either hang up, or enter your
remote access code again and begin
remote operation (page 38).
*1
39
2015/04/07 11:32:51