Toshiba RAV-SP1104AT8-E1 Service Manual page 104

No. Part name
1. Detachment
Compressor
8
IPDU board
1) Carry out the operation in 1. of
MCC-1596
2) Remove the screw (4 positions) fixing the inverter
3) Remove the lead wire and connector to other
4) Slide and remove the inverter assembly (IPDU).
5) Remove the screws (4 positions) fixing the heat
2. Attachment
1) Mount compressor IPDU board.
2) Mount components in the opposite method to that
Procedure
1. of , 1. of and 1. of
assembly (IPDU).
components from the compressor IPDU board.
CN04 : Posister (Red)
CN09 : Power supply terminal block (Yellow)
CN10 : Power supply terminal block (Yellow)
CN11 : Relay (Red)
CN12 : Noise filter board (White)
CN13 : Relay (Black)
CN101 : FAN-IPDU board (3P, White)
CN211 : Compressor (Red)
CN212 : Compressor (White)
CN213 : Compressor (Black)
CN851 : FAN-IPDU board (5P, Red)
∗ Connectors should be removed after unlocking
the housing section.
sink and the screws (3 positions) fixing the
compressor IPDU board and then remove the
compressor IPDU board.
when removing.
, 1. of ,
.
– 104 –
Remarks
Inverter assembly (front)
Screws (4 positions)
Compressor Compressor Compressor
IPDU board IPDU board IPDU board
Screws (3 positions)
State of compressor IPDU board
when removed