Table of Contents
Advertisement
Product Information
Check Paper Width:
Select On to check the paper width before printing. This prevents printing beyond the edges of
the paper when the paper size setting is incorrect, but this may lower the print speed.
Skip Blank Page:
Skips blank pages in the print data automatically.
Auto Error Solver:
Select an action to perform when a 2-sided printing error or a memory full error occurs.
❏ On
Displays a warning and prints in single-sided mode when a 2-sided printing error occurs, or prints
only what the printer could process when a memory full error occurs.
❏ Off
Displays an error message and cancels printing.
Thick Paper:
Select On to prevent ink from smearing on your printouts, however, this may lower the print speed.
Quiet Mode:
Select On to reduce noise during printing, however, this may lower the print speed. Depending on
the paper type and print quality settings you selected, there may be no difference in the printer's noise
level.
Ink Drying Time:
Select the ink drying time you want to use when performing 2-sided printing. The printer prints the
other side after printing one side. If your printout is smeared, increase the time setting.
Output Tray Auto Extension:
Select On to extend the paper output support automatically when printing paper.
PC Connection via USB:
Select Enable to allow a computer to access the printer when connected by USB. When Disable is
selected, printing that is not sent over a network connection is restricted.
Related Information
"Loading Paper" on page 27
&
Network Settings
Select the menus on the control panel as described below.
Settings > General Settings > Network Settings
Wi-Fi Setup:
Set up or change wireless network settings. Choose the connection method from following and then
follow the instructions on the control panel.
>
>
Settings Menu List
General Settings
175
Advertisement
Table of Contents
