Cisco MERAKI MR44 Installation Manual page 14

Getting Power to the AP
If mounting to an electrical junction box, feed the Ethernet cable through the cable access hole in the mount cradle. If
mounting to a wall or ceiling, the Ethernet cable will feed from behind the AP. The "Power Source Options" section of
this document lists the different powering options and their unique characteristics.
Mount the AP
Attach the MR44 AP to the Mount Cradle
(This section applies to wall and/or solid ceiling, drop ceiling, or electrical junction box mount where you have already
installed the mount cradle.)
The MR44 AP attaches to the mount cradle with two tabs on the cradle that insert into the MR44 AP and is secured to
the cradle using one screw.
To attach the MR44 AP to the mount cradle properly, line up the top edge of the AP with the top tab of the mount cradle.
Since the cradle is already mounted to the wall, guide the MR44 AP towards the top tab, and insert the top tab into the
MR44 AP's slot.
14