Checking The Paper Thickness Lever - Epson Stylus Pro XL Setup And Software Manual

10. Press the
11. Close the printer cover.
In order to maintain optimum print quality, the printer
periodically performs a cleaning operation. You may notice the
cleaning cycle being performed when the printer has been on
for a while without being used or when you turn it on after it
has been off for a while.
You may sometimes need to manually activate a cleaning cycle
to clean the print heads if you notice a decline in print quality.
See Chapter 3 of the Reference Guide for instructions.
Note:
When you need to replace ink cartridges, be sure to use only genuine
EPSON ink cartridges and do not refill them. Other products may
cause damage not covered by EPSON's warranty.

Checking the Paper Thickness Lever

After you install the ink cartridges, you should make sure that
the paper thickness lever, which controls the distance between
the paper and the printer carriage, is set correctly:
1. Make sure the printer is turned on.
2. Open the printer cover and press the
3. While holding down the
and release both buttons. The carriage moves left, to the
lever adjusting position, and the
Pause button.
Pause
button, press the
Alt
light flashes.
Data
Installing the Printer
button.
button
Font
1-11