Loading Plain Paper; Checking The Paper Thickness Lever - Epson Stylus Color 200 Manual

EPSON Stylus COLOR 200
10. Press down the ink cartridge clamp until it locks in place.
You will feel some resistance.
11. Press the Load/Eject button again to return the print head
to its home position. (Even if you do not press Load/Eject,
the printer moves the print head back to its home position
about 60 seconds after you close the clamp.)
After you install the black ink cartridge, the printer charges
the ink delivery system. This takes about one minute.
During this time, the Power light flashes. When the printer
finishes charging, the Power light stays on.
c
Caution:
Make sure the printer completes the ink charging process even
if you plan to reinstall the color print head unit. If the charging
process is not completed, the printer may be damaged.
12. Close the printer cover.
c
Caution:


Never turn off the printer while the Power light is
flashing.


When you are ready to discard an ink cartridge, always
remove it from the print head unit first. Do not discard
the print head unit.


When you switch between print head units, always leave
the ink cartridge installed. Once you remove a cartridge,
do not reuse it. Reusing a cartridge that has been removed
may damage the print head.


Use only genuine EPSON ink cartridges and do not refill
them. Other products may cause damage not covered by
EPSON's warranty.
When you want to print in color again, replace the monochrome
print head unit with the color print head unit.

Loading Plain Paper

Checking the Paper Thickness Lever

The paper thickness lever on the right side of the sheet feeder
has two settings: plain paper and thick paper. Set the lever to
the position that best suits the paper or other media you plan to
use, as shown in the following table and illustration.
Paper type
Plain or special paper
Transparencies
Envelopes or labels
EPSON Stylus COLOR 200-10
Paper thickness lever position
Plain paper
Plain paper
Thick paper
You can load up to 100 sheets of plain paper in the sheet feeder.
Be sure to load it with the printable surface facing up. The
printable surface is marked with an arrow on most plain paper
packaging.
1. Push down the left edge guide lock lever; then slide the left
edge guide to the left as far as it will go.
2. Load the stack of paper, printable side up, so that its right
edge rests against the right side of the sheet feeder. Do not
load paper above the arrow mark inside the left edge guide
of the sheet feeder.
6/96
thick paper
setting
plain paper
setting
Ink Jet Printers