Other Functions - Daikin FDYM-PV1 Operating And Installation Instruction Manual

5.14.1 Ambient Temperature Sensor Setting
In fi eld setting mode, press Mode button to adjust the temperature displayed location displaying 00, and press
or button to adjust setting state at timer displayed location. There are 3 types for selection:
(1) Indoor ambient temperature is that at return air inlet (01 is displayed at timer displayed location)
(2) Indoor ambient temperature is that at the place of wired controller (02 is displayed at timer displayed
location)
(3) Return air inlet temperature sensor shall be selected for cooling, dry and fan modes and wired controller
temperature sensor shall be selected for heating and auto modes (03 is played at timer display location).
5.14.2 Three Grades of Speed for Indoor Fan
In fi eld setting mode, press Mode button to adjust the temperature displayed location displaying 01 and press
or button to adjust setting state at timer displayed location. There are 2 types for selection:
(1) 3 low grades (LCD displays 01)
(2) 3 high grades (LCD displays 02)
Three low grades indicate high, medium and low grades and 3 high grades indicate super-high, high and
medium grades.
Press Enter/Cancel button to save the setting and quit after setting. If there is not any operation within 20s
after the system responds the latest button operation in this interface, the system will quit this menu and
display normal off-state; meanwhile, current setting won't be saved.

5.15 Other Functions

5.15.1 Lock Function
Upon startup of the unit without malfunction or under off-state of the unit, press
time for 5s till the wired controller enters lock-state. In this case, LCD displays
two buttons at the same time for 5s to quit lock-state.
Under lock-state, any other buttons won't give any response to the press.
5.15.2 Memory Function
Memory switchover: Under off-state of the unit, press Mode and
memory modes. During setting memory mode, MEMORY will be displayed. If this func-
tion is not set, the unit will be under off-state after power failure and then power recovery.
Memory recovery: If memory mode has been set for wired controller, the wired controller after power failure
will resume its original running state upon power recovery.
Note:
1. It will take about 5s to save all the information. Please don't cut down the power after content changed
in 5 second, or it may be fail to save the content.
5.15.3 Enquiry of Outdoor Ambient Temperature
Under on/off-state of the unit, press Enter/Cancel button for 5s, outdoor ambient temperature will be displayed
at temperature displaying area after a sound of click. Pressing any button, this enquiry state will quit. If there is
not any operation for 20s, it will automatically quit.
Note:
1. This function will be shielded after energization of 12hr for some models of the units without outdoor
ambient sensors. Please refer to Instruction for details.
2. If malfunction of outdoor ambient sensor occurs, this function will be shielded in 12hr.
5.15.4 Selection of Centigrade and Fahrenheit
Under off-state of the unit, press Mode and
and Fahrenheit.
English
buttons at the same time for 5s to switch
at the same time for 5s, the LCD will switch between Centigrade
and buttons at the same
. After that, repress these
21