Panasonic TH-75SQ1W Operating Instructions Manual page 70

Note
● Set the "Power management" function to [On] for
terminals to operate this function.
● [Extended standby mode] is set to [On], and greyed
out.
■
[No signal power off]
When this is set to [Enable], the power supply of the
unit goes off automatically (standby) when there is no
operation or sync signal for about 10 minutes.
Note
● When set to the USB input, the unit determines no
signal is present if the USB memory is not connected
to the USB terminal, or the connected USB memory
does not contain any playable file.
●
With Screen Transfer input, the unit determines no
signal is present in standby status and when the PC
is not connected to Screen Transfer.
●
This function operates regardless of the [On] / [Off]
settings of [No signal image settings].
●
This function may not operate depending on the video
output devices.
■
[HDMI1 power management]
When this function is set to [On], it operates under
the following conditions to turn the power on or off
automatically.
When no pictures (sync signal) are detected for
60 seconds or so at HDMI1 input:
Power is turned off (standby); the power indicator
lights up orange.
When pictures (sync signal) are subsequently
detected at HDMI1 input:
Power is turned on; the power indicator lights up
green.
Note
●
This function may not operate depending on the video
output devices.
■
[HDMI2 power management]
When this function is set to [On], it operates under
the following conditions to turn the power on or off
automatically.
When no pictures (sync signal) are detected for
60 seconds or so at HDMI2 input:
Power is turned off (standby); the power indicator
lights up orange.
When pictures (sync signal) are subsequently
detected at HDMI2 input:
Power is turned on; the power indicator lights up
green.
Note
●
This function may not operate depending on the video
output devices.
70
English
■
[DisplayPort power management]
When this function is set to [On], it operates under
the following conditions to turn the power on or off
automatically.
When no pictures (sync signal) are detected for
60 seconds or so at DisplayPort input:
Power is turned off (standby); the power indicator
lights up orange.
When pictures (sync signal) are subsequently
detected at DisplayPort input:
Power is turned on; the power indicator lights up
green.
Note
●
This function may not operate depending on the video
output devices.
■
[DIGITAL LINK power management]
When this function is set to [On], it operates under
the following conditions to turn the power on or off
automatically.
When no pictures (sync signal) are detected for
60 seconds or so at DIGITAL LINK input:
Power is turned off (standby); the power indicator
lights up orange.
When pictures (sync signal) are subsequently
detected at DIGITAL LINK input:
Power is turned on; the power indicator lights up
green.
Note
●
This function may not operate depending on the video
output devices.
●
When this function is set to [On], set [Quick start] to
[On] to enable the operation.
●
When [Quick start] is set to [Off], if images are not
detected, the unit enters the standby state even if it is
set to [On]. However, the unit does not start up even
if images are detected again. To operate the power
management function, it is necessary to set both
[Quick start] and [DIGITAL LINK power management]
to [On] respectively.
■
[DVI-D power management]
When this function is set to [On], it operates under
the following conditions to turn the power on or off
automatically.
When no pictures (sync signal) are detected for
60 seconds or so at DVI-D input:
Power is turned off (standby); the power indicator
lights up orange.
When pictures (sync signal) are subsequently
detected at DVI-D input:
Power is turned on; the power indicator lights up
green.
Note
●
This function may not operate depending on the video
output devices.