Epson Stylus Photo 870 Printer Basics Manual page 40

5. Load the end of the paper into the printer as far as it will go, then slide the left
edge guide against the paper.
4-inch wide roll paper
6. Gently hold the paper in place on the top as you press and release the E load/eject
button to feed the paper into the printer.
4-inch wide roll paper
(If the paper feeds incorrectly, pull it out backward and reload it. If it won't come
out, hold down the E load/eject button for three seconds to feed the paper
backward to where you can pull it out. Then reload it, making sure the end is
straight and not damaged. If necessary, trim the end again before reloading as
shown in step 1.)
7. Gently rotate the roll backward to remove any slack from the paper.
8. Make sure the output tray is open but the extensions are closed, and leave ample
room at the front of the printer for your paper to eject smoothly.
9. Follow the steps in the next section to print on the roll paper.
13-inch wide roll paper
13-inch wide roll paper
35